Fixed Code Programming - Ford Super Duty Owner's Manual

172 Universal Garage Door Opener (If Equipped)

Fixed Code Programming

Note: It may be helpful to have another person assist you in
2. Open the battery cover and note all the switch settings from left to
right.
When the switch is in the up, on, or + position, mark down "left button".
When the switch is in the middle, neutral, or 0 position, mark down
"middle button".
When the switch is in the down, off, or – position, mark down "right
button".
4. Enter the corresponding DIP switch settings from left to right into the
system by pressing and releasing the buttons corresponding to the settings
you noted.
5. Simultaneously press and release all three function buttons. The LED
lamps will illuminate.
2013 F-250/350/450/550 (f23)
Owners Guide gf, 2nd Printing, December 2012
USA (fus)
programming the transmitter.
To program units with fixed code
DIP switches, you will need the
garage door hand-held transmitter,
paper and a pen or pencil.
1. Switch the ignition on.
3. Press all three function buttons
simultaneously for a few seconds
and then release. The LED lamps
will flash slowly.
Note: The following step must be
completed within 2.5 minutes.
6. Press and hold the function
button you would like to use to
control the garage door.
Note: You may need to hold the
button from 5–55 seconds before
observing movement of the garage
door.