Reprogramming A Single Button; Programing The Transmitters; Programming Homelink® To A Genie Intellicode® 2 Garage Door Opener - Ford EXPLORER 2013 Owner's Manual

Universal Garage Door Opener (If Equipped) 197
Erasing the Function Button Codes

Reprogramming a single button

To program a device to a previously trained button, follow these steps:
1. Press and hold the desired button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.
For questions or comments, contact HomeLink® at www.homelink.com
or 1-800-355-3515.
Programming HomeLink® to a Genie Intellicode® 2 garage door
opener
Note: The Genie Intellicode® 2 transmitter must already be
programmed to operate with the garage door opener.

Programing the transmitters

To program HomeLink® to the transmitter you must first put the
transmitter into programming mode. To do this:
A
1. Press and hold one of the buttons on the hand-held transmitter for
10 seconds. The LED light will change from green to green and red.
2013 Explorer (exp)
Owners Guide gf, 4th Printing, November 2012
USA (fus)
Note: You cannot erase individual
buttons.
1. Press and hold the outer two function
buttons simultaneously for approximately
20 seconds until the indicator lights above
the buttons flash rapidly.
2. When the indicator lights flash, release
the buttons. The codes for all buttons are
erased.
A. Red LED
B. Green LED
B