Ccb - Create Configuration Storage Block - GE 68K System User Manual

GE Energy Services

CCB - Create Configuration Storage Block

o
CPM
Platform
Use this command to create the configuration storage block at a specified location or
Description
allocate it out of RAM.
The amount of memory space allocated to configuration storage and other relevant
parameters are also required.
•
The Monitor invalidates any existing storage block before creating the new one.
−
−
Syntax Below is usage and syntax information for this command
!
Any existing stored configurations will be lost when this command is invoked!!!
WARNING
Command Format
Variables
Parameters
3-12
o o
D20 D20 ME
D20 Base D20 Base
If requested to make the block in NVRAM, the command assumes it to be a
part of a static configuration storage region and will simply use the memory
as specified (base address and size).
By specifying RAM, the monitor expects the block to be temporary, and
allocates memory out of normal pSOS RAM.
ccb [/(n | v | r)] base_address total_ram response_file_size
num_cfgs nvram_base
/n =
/v =
/r =
base_address = Address of start of configuration storage
total_ram
response_file_size
num_cfgs
nvram_base = Address of start of NVRAM region.
SWM0023 1.00 2
þ þ
D20/200
CCU Base
Build configuration block in global NVRAM
region using the base_address supplied.
Allocate the configuration block from normal
RAM, ignoring the base address.
Reset CCB. Old CCB is cleared before new one
created
region, in hexadecimal (must be present, even
if it's just zero for RAM configuration
blocks).
= Total amount of NVRAM allocated to the
region, in bytes.
= Size of response file, in bytes.
= Total number of configurations to store,
maximum of 2.
68K System Monitor
User's Guide
þ
D20/200 ME D25
CCU Base
Continued on next page
General
Full Release