Cabinet Assembly - Axminster AWHBS350N Instructions Manual

Unpacking
Your saw is packed in the box partially assembled.
This is to ensure that the components are inserted
in the correct positions. e.g. The blade is fitted, the
securing bolt for the tilt mechanism is inserted in
the tilt quadrant with the washer and the locking
butterfly nut threaded on to the bolt, etc.
Please make careful note of the positions of
the various components if you have cause to
disassemble, whilst putting the machine together.
Take all the easily removable items out of the box,

Cabinet Assembly

Support plate
Attach the two connecting plates
Base
tip the box up so that the base of the saw is to the
ground, remove all the polystyrene packaging from
around the saw (open both sides of the box?) then
"corner walk" the saw out of the box.
If this is still awkward, split the top of the box, fold the
box material flat on the floor, and "wriggle" the saw
off the cardboard. (The best method of moving the
saw is with a 'hug' lift through the neck of the saw,
holding the saw back against your body and lifting
by straightening your legs).
Step 1
M6 x 12 bolts and washers
Step 2
Lightly tighten the M6 x12 bolts and washers
6