Axminster AWHBS350N Instructions Manual page 17

Lower saw
wheel
Drive belt
tensioning
idler wheel
Dust extraction
outlet
On/Off Button
and switch
shroud
The lower saw wheel and integral pulley wheel is likewise mounted on double
bearings, onto an axle that is mounted to a fixed base plate. The base plate, triangular
in shape, is bolted to the rear face of the lower saw wheel compartment. There are no
adjustment mechanisms for the lower saw wheel. Mounted on a fixed shaft on a fixed
base it is the base parameter that the rest of the saw is set against.
The drive belt tensioning idler wheel, is mounted on a stub axle assembly.
The idler wheel adjusting knob, is connected to a threaded rod which is engaged in
the stub axle assembly. Remember; the idler wheel should be against the outside
of the belt, (see fig 10d) slightly tension the belt by turning the idler wheel
adjusting knob clockwise.
A 100mm diameter dust extraction outlet.
The On/Off buttons, fitted with the optional shroud, (see the initial assembly
instructions).
Illustration and Parts Description
17