Schwinn 150 Upright Bike Assembly Manual page 44

Condition/Problem
Console shuts off (enters
sleep mode) while in use
Fan will not turn on or will
not turn off
44
Things to Check
Check electrical (wall)
outlet
Check connection at rear
of unit
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Solution
Make sure unit is plugged into a func-
tioning wall outlet.
Connection should be secure and un-
damaged. Replace adapter or connec-
tion at unit if either are damaged.
All wires in the cable should be intact. If
any are cut or crimped, replace cable.
Be sure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Unplug unit from electrical outlet for 3
minutes. Reconnect to outlet.
Magnet should be in place on pulley.
Contact Customer Care for further
assistance.
All wires in cable should be intact. If any
are cut or crimped, replace cable.
Be sure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Unplug unit from electrical outlet for 3
minutes. Reconnect to outlet.