Fan (if equipped) will not
turn on or will not turn off
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check leveler adjustment
Check surface under unit
Check pedal to crank con-
nection
Check crank to axle con-
nection
Check pedal to crank con-
nection
Check locking pin
Check adjustment knob
All wires in cable should be intact. If any
are cut or crimped, replace cable.
Be sure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Unplug unit from electrical outlet for 3
minutes. Reconnect to outlet.
Leveling feet may be turned in or out to
level bike.
Adjustment may not be able to com-
pensate for extremely uneven surfaces.
Move bike to level area.
Pedal should be tightened securely to
crank. Be sure connection is not cross-
threaded.
Crank should be tightened securely to
axle.
Remove pedals and reattach fully.
Be sure adjustment pin is locked into
one of the seat post adjustment holes.
Be sure knob is securely tightened.
37