Canon LBP3200 User Manual page 227

White dust is attached to the printed transparencies.
Cause
Remedy
Print is partially hollowed out.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
6
Remedy
Paper curls.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Cause 4
Remedy
6-20 Print Quality Problems
The transparencies were printed just after other type of paper was printed
continuously.
If you make continuous print on other type of paper before printing on
transparencies, the transparencies may come out with chipped paper attached.
In this case, wipe and remove the chipped paper with a soft cloth.
Proper paper is not being used.
Replace the paper with a type that can be used with this printer. (See "Paper
Requirements," on p. 2-2.)
Paper is damp.
Replace paper with an unpacked stack.
The drum in the toner cartridge has deteriorated.
Replace the toner cartridge with a new one. (See "Replacing the Toner
Cartridge," on p. 5-2.)
Paper is damp.
Replace paper with an unpacked stack.
Proper paper is not being used.
Replace the paper with a type that can be used with this printer. (See "Paper
Requirements," on p. 2-2.)
Paper was delivered into the face-down delivery area.
If you are using paper that curls easily, change the paper delivery area to the
face-up delivery slot. (See "Paper Delivery Area," on p. 2-11.)
Paper is too thin.
Specify [Paper Type] to [Plain Paper L] in the printer driver.
In order to specify [Paper Type], open the [Page Setup] sheet.