Setting Up The Camera; Camera Positioning - Bosch VDN-5085 Installation Manual

20 en | Connection and set-up
4.2

Setting up the camera

4.2.1

Camera positioning

CAUTION!
The Heater will be hot when in operation - Do not touch.Always
switch the heater off when working on the camera, refer to
Section 4.2.4 Heater, page 23 and Section 5.6.4 Connections
submenu, page 41.
To assist in setting up the camera, connect a monitor to the
miniature 2.5 mm jack socket (2). This socket provides a
composite video signal (with sync). An optional cable (code
number S1460) is available for making this connection. When
the S1460 cable is attached, there is no video available on the
BNC connector to avoid interference.
Figure 4.1 Camera parts
1.
2.
AM18-Q0648 | v1.0 | 2013.03
C
Heater
Monitor jack socket
Installation Manual
FLEXIDOME 5000 AN
A
B
Bosch Security Systems