Mounting The Unit - Bosch VDN-5085 Installation Manual

14 en | Installation
Figure 3.2 Surface-mount
To disassemble the unit proceed as follows:
1.
2.
3.
4.
3.3

Mounting the unit

There are several ways to mount the unit. The method of
mounting depends on the type of surface and whether other
mounting hardware, such as an electrical box, a surface box or
other accessories are used.
Note:
AM18-Q0648 | v1.0 | 2013.03
Surface mounting box
Camera module and mounting base
Inner liner (with sealing ring)
Trim ring
Dome
Use the special screwdriver bit to loosen the three tamper-
resistant screws in the trim ring (the screws remain in
place).
Remove the trim ring and dome by pulling them from the
base.
Remove the inner liner (with sealing ring) by pulling it off
of the base.
Remove the pink protective foam.
Installation Manual
FLEXIDOME 5000 AN
Bosch Security Systems