Attach The Mounting Plate To A Concrete Or Concrete Block Wall - K2 Mounts K2-F-Series Installation Manual

Attach the Mounting Plate to a Concrete or Concrete Block Wall

If you ar e mounting your TV on a dry wall or plaster wall with wood studs, do not use this section.
Go to "Attach the Mounting Plate to a Wood Stud Wall" on page 7.
Warning: Mounting Plates can only be installed on a concrete or
concr ete block wall. Attaching the wall mount to a brick wall could result
in pr operty damage or personal injury.
(A) Determine Mounting Hole Locations
Using the level and measuring ta pe, make a mark 3-1/8" dir ectly above and 3-1/8" directly
belo w the Mounted TV Center Point. These marks are the Upper and Lower Center Points.
K2-F-SERIES, K2-T-SERIES, K3-F-SERIES, K3-T-SERIES
Hold the Mounting Plate against the wall, aligning the center of the Mounting Plate with the
Mounted TV Center P oint. Now move the Mounting Plate so that the Upper and Lo w er
Center P oints are visible through tw o slots in the Mounting Plate. Using the Mounting Plate
as a template , mark the wall within the four corner slots. These four marks are the Mounting
Hole Locations.
Using the le vel, make sure each set of three marks on the wall is on a straight and level
horizontal line .
(B) Drill Holes and Install Anchors
Using the drill and 1/2" masonry drill bit, drill pilot holes 2-1/2" deep at all Mounting Hole
Locations.
Insert a Concrete Anchor into each of the holes, using the hammer to tap the anchors in
place if necessary. Make sure that the anchor is completely flush with the concrete surface
even if there is a layer of drywall or other material in front of the concrete.
9
www.k2mounts.com
Rev00