K2 Mounts K2-F-Series Installation Manual page 9

(B) Determine Mounting Hole Locations
Mounting Hole Locations
(C) Anchor Mounting Plate to the Wall
Hold the Mounting Plate against the wall, roughly aligning the center of the Mounting Plate
with the Mounted TV Center Point. Now move the Mounting Plate so that the pilot holes ar e
visible thr ough the slots.
Using the ratchet and 7/16" sock et, anchor
each Mounting Plate into the wall with f our
1/4" x 2/1/2" Lag Bolts and four Mounting
Plate W ashers.
Warning :
W arning: On each Mounting Plate, you m ust fasten all four Lag Bolts
securely into wall studs for proper installation. Failure to do so could result
in property damage or personal injury.
To continue installation, go to "Attach the Screen Mounting Brackets to the TV " on page 11.
Rev00
Using the level and measuring ta pe, make a mark
3-1/8" directly above and 3-1/8" directl y below the
Mounted TV Center P oint. These marks are the
Upper and Lower Center P oints.
Using the le vel, draw a horizontal (side-to-side) line
through the Upper Center Point that connects all
stud centerlines. Dra w a similar line through the
Lower Center P oint.
The intersection of the horizontal lines with the stud
centerlines ar e the Mounting Hole Locations. Using
the drill and 1/8" drill bit, drill pilot holes 2-1/2" deep
into the stud at each intersection point.
.
www.k2mounts.com 8