Table of Contents
Advertisement
18
en | Operation via the browser
Pre-position
To move the camera to a pre-position, click one of the buttons
numbered one to six.
To store the current position of the camera in a pre-position:
1.
2.
3.
3.1.4
View Control ROI
When the stream 2 encoder stream is set for Region of Interest
(ROI), a specific type of View Control panel is activated.
Refer to Section 9.3 Encoder Regions, page 66 for more
information on setting up stream 2. (When encoder stream 2 is
set for dual ROI, open the camera in a second browser window
to set up the second ROI on stream 2.)
Zoom
To zoom in on a region of the stream 2 image:
Select an area
To select a particular region of the image:
1.
2.
AM18-Q0635 | v5.6 | 2013.01
Position the camera.
Enter a pre-position number.
Click Set.
Click and hold
zoom out.
Click
to see the full image.
Click and hold the arrows to move up and down, and from
side to side through the image.
Click and hold the center area to move in all directions.
Software manual
Camera Browser Interface
to zoom in; click and hold
to
Bosch Security Systems
Advertisement
Table of Contents
