Auto Setup For The Pc - IBM T74 Manual

bain-e.backup.backup.fm Page 7 Thursday, September 9, 1999 5:03 PM
Before carrying out this
section, it is very important
that The Setup Diskette for
Windows 95 or Windows 98
has been run. (see page 6)
If your PC does not run
with the setup diskettes
shipped with the monitor, refer
Manual Setup
to on page 13
A
The process
UTO SETUP
only applies to the current
screen mode. When a new
mode is selected, repeat this
section to reset the monitor
Locate the operating system installed on your PC in the table below and
follow the appropriate instructions. You may choose to run
each operating system that you use. This means that if you sometimes use
your monitor while running any version of Windows and sometimes also use
it from within DOS (not a DOS window), you must run
Windows and DOS. You may run versions of
Operating System
DOS
Windows 3.1
Windows 95
Windows 98
Window NT
Operating System/2 (OS/2)
Before you begin
A S
UTO ETUP
1. Make a backup copy of the setup diskettes supplied with the monitor.
2. Make sure the PC's video mode is set in the range of the supported
screen resolution shown in the table on page 19.
You should perform
A S
UTO

Auto Setup for the PC

A S
UTO ETUP
Corresponding Auto Setup procedure
Auto Setup for DOS
Auto Setup for Windows 3.1, Windows 95,
Windows 98 or Windows NT
Auto Setup OS/2
for your PC:
for each screen mode you use.
ETUP
for
A S
UTO ETUP
for both
A S
UTO ETUP
in any order.
on page 8
on page 9
on page 11
7