Electrical Requirements - American Dryer Corp. ML-130 III Installation Manual

Phase 7 / hsi and dsi / dual timer / f.s.s.

Table of Contents

Typical water supply...

Optional Manual Bypass

Provisions are made in the dryer F.S.S. for the installation of

an optional manual bypass. Depending on the model dryer,

the connections for the manual bypass are made at the "T"

or "three way" fitting located in the outlet supply side of the

water solenoid valve. The use and connections of this manual

bypass are at the option or discretion of the owner.

The water connection for the manual bypass is made to the

"T" or "three way" fitting, which has a 3/8" F.P.T. and a coupling

must be used to provide the minimum 1/2" supply (feed) line.

If the rear area of the dryer, or the water supply is located in

an area where it will be exposed to cold/freezing

temperatures, provisions must be made to protect these water

lines from freezing.

WARNING

If the water in the supply line or water solenoid

valve freezes, the F.S.S. will be inoperative!!

The manual ball cock shutoff valve must be located outside

of the dryer at a distance from the dryer where it is easily

accessible.

Electrical Requirements

No independent external power source or supply connection

is necessary. The 24 volt power to operate the F.S.S. is

accomplished internally in the dryer (from the dryer controls).

113335 - 12

Electrical power must be provided to the dryer at

all times. If the main electrical power supply to

the dryer is disconnected, the F.S.S. is

inoperative!!

Notes ______________________________________________________

____________________________________________________________

www.amdry.com

WARNING

Table of Contents

Ml-130dr