Installing The Switch; Installing The Control Unit - Alpine ACTIVE VIEW HCE-C305R Owner's Manual

4. Installing the Switch

1
Attach the switch L according to the
following illustration.
Attach the supplied switch adhesive sheet
M. Peel off the protective sheet, and apply
it to the back of the switch, then peel off
the other protective sheet and install in the
desired location. If necessary, secure the cable
with the supplied cord clamps N.
• Before attaching the switch, wipe off any dust, oil,
etc., on the attaching surface with a suitable cleaning
cloth (sold separately).
•
Attach the switch in a location where driving is not
hindered.

5. Installing the Control Unit

1
Attach the control unit B with the Velcro
fastener F or self-tapping screw G.
•
It is recommended to install the control unit on the
rear of the instrument panel, or under a seat.
e
Attaching with Velcro fastener
(1) Attach the Velcro fastener (hard side)
F to the bottom of the control unit B.
Velcro fastener
•
Attach the Velcro fastener in an area on the bottom
of the unit undersurface where the label is not
attached.
(2) Attach the Velcro fastener (soft side)
F to the floor, and secure the control
Switch
unit B.
When attaching the Velcro fastener (hard side) F
•
to the floor carpet, do so without the Velcro fastener
(soft side) F attached.
e
Attaching with the self-tapping screw
(1) Attaching the control unit with the
self-tapping screw G in a flat location.
Control unit
Control unit
21
-EN