Connecting The Console Monitor; Connecting Servers (Bsus) To The Concentrator - NEC Express 5800 User Manual

Connecting the Console Monitor

Perform the following steps to connect the console monitor to the concentrator.
1. The keyboard, mouse, and video display cables attach to the first group of
connectors on the left of the concentrator when viewed from the rear. See
Figure 5-15.
2. The top-most connector is for the monitor (Figure 5-15, A). Below the
monitor connector, connect the keyboard to the keyboard connector (K) and
connect the mouse to the mouse connector (M).
Note: If necessary, you can use 12-ft extension cables to
achieve overall cable lengths of 19-ft or 24-ft to
accommodate the placement of your console monitor on
external desktop.
One
Figure 5-15. Connecting Cables to the Port Concentrator

Connecting Servers (BSUs) to the Concentrator

1. Connect the keyboard, mouse, and video display cable from each server to
one of the concentrator connector groups labeled one through eight. See
Figure 5-15.
2. Attach the AC power cord to the receptacle located next to the power on/off
switch on the right side of the concentrator when viewed from the rear.
Connect the other end of this power cord to the PDU or UPS.
Two Three Four
A
Reset
M
K
Five Six Seven
One
M
K
Installing Rack Components 5-19
Eight