Tools Required; Installing Rack Components - NEC Express 5800 User Manual

Tools Required

In addition to the materials shipped to you and standard hand tools, you will
need:
#2 and #3 Phillips-head screwdrivers to assemble rack-mounting
!
hardware, and
a 3mm Allen wrench and 4mm nut driver to tighten the monitor tray
!
mounting posts

Installing Rack Components

In general, the installation of a rack unit requires the:
Installation of cage-nuts at the rail locations used to secure the front
!
bezel of a unit to the rack. Figure 5-1 shows a typical installation of the
cage-nuts.
Installation of mounting hardware, usually chassis slide rails or
!
L-brackets
Installation of the unit into its mounting hardware and then securing the
!
unit to the rack
Connection of AC power and data cables
!
Note: If using this document for an upgrade of existing
equipment, be sure that all external cables connected to the
system unit are disconnected before sliding the unit out from
the rack.
Figure 5-1. Installing Rack Hardware
Installing Rack Components 5-3