VTech VM301 User Manual page 12

Getting started
Baby unit installation options (continued)
Option 2: Use this method so that you can relocate the baby unit with the wall
mount easily.
1. Place the wall mount on a wall and then use a pencil to mark the top and
the bottom holes as shown. Then remove the wall mount and drill two
holes in the wall (7/32" drill bit). Check for reception strength and camera
angle before drilling the holes.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall
anchors into the holes and tap gently on the ends with a hammer until the
wall anchors are flush with the wall.
7