VTech VM302 User Manual

What's in the box
User's manual
(Canada version)
VM302
Accessory baby unit
for use with VTech model
VM312/VM312-2
Connect the baby unit
NOTES
• Use only the baby unit power adapter supplied
with this product.
• Make sure the electrical outlet is not controlled by
wall switch.
• The baby unit power adapter is intended to be
correctly oriented in a vertical or floor mount
position. The prong are not designed to hold the
plug in place if it is plugged into a ceiling, under-
the-table or cabinet outlet.
• Make sure the baby unit and the power adapter
cord are out of reach of children.
Congratulations
on purchasing your new VTech product.
2
Before using this product, please read
Important safety instructions.
This manual has instructions on how to set
up and pair your new baby unit. For complete
instructions on using the baby unit, see the
user's manual that came with your video and
audio monitor.
For support, shopping, and everything new at
VTech, visit our website at
www.vtechcanada.com.
Overview
1 Infrared LEDs
Backup light for night vision.
2 POWER on/off indicator
• On when the baby unit is powered on
and currently linked to parent unit.
• Flashes when the baby unit is not
linked to a parent unit; or the pairing
process is in progress; or the parent
unit is not viewing this baby unit.
3 Power jack
4
(On/Off)
• Press to power on.
• Press and hold to power off.
5 Night sensor
6 Camera
7 /VOL
Press to increase the listening volume.
1
8 PAIR
Press and hold to pair to the parent unit.
9 /VOL
Press to decrease the listening volume.
10 Microphone
11 Speaker
12 Ball joint stand
Pan or tilt to adjust the camera angle.
13 Base
When unpairing is successful, the POWER
Before use
light on the selected baby unit flashes. The
parent unit displays
Pair and replace extra new baby unit image from the baby unit previously viewing.
Each newly purchased baby units (VM302)
Positioning the baby monitor
must be paired to your video and audio monitor
system (VM312/VM312-2).
NOTE
NOTES
This baby monitor is intended as an aid. It is not a
• You can pair a maximum of four baby units to substitute for proper adult supervision, and should not
be used as such.
your parent unit. Each new baby unit must be
paired to the parent unit before use.
CAUTION
• Make sure you power on the parent unit before
Keep the baby unit out of the reach of the baby. Never
pairing.
place or mount the baby unit inside the baby's crib or
playpen.
To pair and replace a baby unit:
1. Place the baby unit at least 1 meter / 3 feet
1. Press MENU/ when the parent unit
SELECT
away from your baby.
is not in use.
2. Press VOL or VOL to choose .
3. Press or to choose a desired baby unit
slot, then press /SELECT. The screen
MENU
displays .
NOTE
If you choose an occupied baby unit slot, the new
baby unit will replace the existing baby unit.
4. Press and hold on the new baby unit
until the POWER light flashes.
Then immediately press and hold PAIR
until the POWER light turns on.
When pairing is successful, the screen displays NOTE
, and then the image from the newly paired If you experience audio feedback on either the parent
unit or baby unit, move the parent unit further away
baby unit.
until there is no more audio feedback; or press VOL
NOTES on the parent unit to lower the audio feedback sound.
• If pairing fails, the screen displays . Try the Place the parent unit at least 1 meter / 3
2.
pairing process again. feet away from the baby unit.
• Only one baby unit can be paired at a time.
To unpair a baby unit:
NOTE
Make sure you power on the baby unit and the parent At least 1 meter (3 feet)
unit before unpairing the baby unit.
1. Press MENU/ when the parent unit
SELECT
is not in use.
2. Press VOL or VOL to scroll to .
3. Press or to select the desired baby unit
TIP
(1, 2, 3 or 4).
You can increase the speaker volume of the parent unit
4. Press and hold TALK until and
if you cannot hear the sounds transmitted from the baby
display.
unit.
5. Press or to select to cancel, or to
confirm the unpair process.
6. Press /SELECT to confirm your selection.
MENU
Operating range
The operating range of the baby monitor is
for a while, and then the
up to 300 meters (1,000 feet) outdoors or
50 meters (160 feet) indoors. The actual
operating range may vary depending on
the environmental conditions, and other
interferences such as walls, doors, and other
obstructions.
General product care
To keep this product working well and looking good,
follow these guidelines:
• Avoid putting it near heating appliances and
devices that generate electrical noise (for example,
motors or fluorescent lamps).
At least 1 meter (3 feet)
• DO NOT expose it to direct sunlight or moisture.
• Avoid dropping the product or treating it roughly.
• Clean with a soft cloth.
• DO NOT immerse the baby unit in water and do
not clean them under the tap.
• DO NOT use cleaning spray or liquid cleaners.
• Make sure the baby unit is dry before you
connect them to the mains again.
Important safety
instructions
When using your equipment, basic safety
precautions should always be followed to reduce the
risk of fire, electric shock and injury, including the
following:
1. Follow all warnings and instructions marked on
the product.
2. Adult setup is required.
3. This product is intended as an aid. It is not
a substitute for responsible and proper adult
supervision and should not be used as such.
4. This product is not intended for use as a medical
monitor.
5. Do not use this product near water. For example, do
not use it next to a bath tub, wash bowl, kitchen sink,
laundry tub or swimming pool, or in a wet basement
or shower.
6. Use only the adapter included with this product.
Incorrect adapter polarity or voltage can seriously
damage the product.
Baby unit power adapter: Input 100-240V AC
150mA 50/60Hz; Output: 6V DC 600mA.
7. The power adapter are intended to be correctly
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
8. Unplug this product from the wall outlet before
cleaning. Do not use liquid or aerosol cleaners.
Use a damp cloth for cleaning.
9. Do not cut off the power adapter to replace it with
other plug, as this causes a hazardous situation.
10. Do not allow anything to rest on the power cords.
Do not install this product where the cords may be
walked on or crimped.
11. This product should be operated only from the
type of power source indicated on the marking
label. If you are not sure of the type of power
supply in your home, consult your dealer or local
power company.
12. Do not overload wall outlets or use an extension
cord.
13. Do not place this product on an unstable table,
shelf, stand or other unstable surfaces.
14. This product should not be placed in any area
where proper ventilation is not provided. Slots and
openings in the back or bottom of this product
are provided for ventilation. To protect them from
overheating, these openings must not be blocked
by placing the product on a soft surface such as
a bed, sofa or rug. This product should never be
placed near or over a radiator or heat register.
15. Never push objects of any kind into this product
through the slots because they may touch
dangerous voltage points or create a short circuit.
Never spill liquid of any kind on the product.
16. To reduce the risk of electric shock, do not
disassemble this product, but take it to an
authorized service facility. Opening or removing
parts of the product other than specified access
doors may expose you to dangerous voltages
or other risks. Incorrect reassembling can cause
electric shock when the product is subsequently
used.
17. You should test the sound reception every
time you turn on the units or move one of the
components.
18. Periodically examine all components for damage.
19. Be aware of possible loss of privacy while using
public airwaves. Conversations may be picked
up by other nursery monitors, cordless phones,
scanners, etc.
20. Children should be supervised to ensure that they
do not play with the product.
21. The product is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
SAVE THESE INSTRUCTIONS