VTech VM305 User Manual

What's in the box
User's manual
(Canada version)
VM305
Accessory baby unit
for use with VTech model
VM343
Connect the baby unit
NOTES
• Use only the power adapter supplied with this
product.
Congratulations
• Make sure the electrical outlet is not controlled by
wall switch.
on purchasing your new VTech product. Before
• The power adapter is intended to be correctly
using this product, please read Important
oriented in a vertical or floor mount position. The
safety instructions.
prongs are not designed to hold the plug in place if
they are plugged into a ceiling, under-the-table or
This manual has instructions on how to set
cabinet outlet.
up and pair your new baby unit. For complete
• Make sure the baby unit and the power adapter
instructions on using the baby unit, see the
cord are out of reach of children.
user's manual that comes with your video and
audio monitor.
For support, shopping, and everything new at
VTech, visit our website at
www.vtechcanada.com.
Overview Before use
f Pair extra new baby unit
Each newly purchased baby unit (VM305)
must be paired to your video and audio monitor
a
system (VM343).
g
b
NOTES
c h
• You can pair a maximum of four baby units to your
parent unit. Each new baby unit must be paired to
i the parent unit before use.
d
• Make sure you power on the parent unit before
e
pairing.
j
To pair a baby unit:
k
1. Press MENU when the parent unit is not in
use.
l 2. Press or to choose PAIR/UNPAIR
CAM, then press SELECT to select.
m to choose Pair CAM, then
3. Press or
press SELECT to select.
4. Press or to choose an empty baby unit
slot, then press SELECT. The parent unit
screen displays Press and hold the pair
1 Light sensor
button at the CAM for 5 seconds until the
power indicator flashes..
2 Infrared LEDs
5. Immediately press and hold PAIR on the
Camera
3
bottom of the baby unit. The LED light
flashes quickly.
4 Microphone
When pairing is successful, the screen displays
5 Speaker
the view of newly paired baby unit in
SINGLE-CAM mode. The LED light on the new
Antenna
6
baby unit remains on.
7 Power jack
NOTES
8 Temperature sensor
• If pairing fails, the screen displays Pairing failed.
Try the pairing process again.
9 ON/OFF LED light
• Only one baby unit can be paired at a time.
• On when the baby unit is turned on.
• Flashes when the baby unit is pairing to
To unpair a baby unit:
the parent unit.
NOTE
10 ON/OFF switch
Make sure you power on the baby unit and the parent
• Slide to turn on or off the baby unit.
unit before unpairing the baby unit.
11 -/VOL/+ 1. On the idle parent unit, press MENU.
• Press to adjust the listening volume. 2. Press or to choose PAIR/UNPAIR
CAM, then press SELECT to select.
12 PAIR
3. Press or to choose Unpair CAM, then
• Press and hold to pair to the parent unit
press SELECT to select.
when an empty baby unit slot is chosen
4. Press or to choose a desired baby unit,
at the parent unit.
then press SELECT.
13 Threaded socket
• For wall mount installation use.
Operating range
5. Press on the parent unit when the screen
displays To unpair CAM X, press the
The operating range of the baby monitor is up to
[ZOOM] key at the Parent Unit..
6. Press SELECT when the screen displays 300 meters (1,000 feet) outdoors or 50 meters
Then, press the [MENU/SELECT] key to
(160 feet) indoors. The actual operating range
confirm..
may vary depending on the environmental
7. When unpairing is successful, the screen
conditions and other interferences such as
displays CAM X is unpaired and returns to
walls, doors and other obstructions.
previous menu. If there is no paired baby
unit, the screen displays No CAM is paired..
The LED light on the selected baby unit
flashes slowly. General product care
Positioning the baby monitor
To keep this product working well and looking good,
follow these guidelines:
NOTE
• Avoid putting it near heating appliances and
This baby monitor is intended as an aid. It is not a
devices that generate electrical noise (for example,
substitute for proper adult supervision, and should not
motors or fluorescent lamps).
be used as such.
• DO NOT expose it to direct sunlight or moisture.
CAUTION • Avoid dropping the product or treating it roughly.
• Clean with a soft cloth.
Keep the baby unit out of the reach of the baby.
• DO NOT immerse the baby unit in water and do not
Never place or mount the baby unit inside the baby's
clean them under the tap.
crib or playpen.
• DO NOT use cleaning spray or liquid cleaners.
1. Place the baby unit at least 1 meter / 3 feet
• Make sure the baby unit is dry before you connect
away from your baby. them to the mains again.
Important safety instructions
When using your equipment, basic safety precautions
should always be followed to reduce the risk of fire,
electric shock and injury, including the following:
1. Follow all warnings and instructions marked on
the product.
2. Adult setup is required.
3. This product is intended as an aid. It is not
2. Place parent unit at least 1 meter / 3 feet
a substitute for responsible and proper adult
away from the baby unit.
supervision and should not be used as such.
4. This product is not intended for use as a medical
monitor.
At least 1 meter
5. Do not use this product near water. For example,
(3 feet)
do not use it next to a bath tub, wash bowl,
kitchen sink, laundry tub or swimming pool, or in a
wet basement or shower.
6. Use only the adapters included with this product.
Incorrect adapter polarity or voltage can seriously
NOTE damage the product.
Baby unit power adapter:
If you experience audio feedback on either the parent
Input 100-240V AC 50/60 Hz; output: 6V DC 1A
unit or baby unit, move the parent unit further away
For pluggable equipment, the socket-outlet shall
until there is no more audio feedback; or press -/VOL
be installed near the equipment and shall be
on the parent unit to lower the audio feedback sound.
easily accessible.
TIP
7. The power adapters are intended to be correctly
oriented in a vertical or floor mount position. The
For desktop usage and/or wall mounting the baby
prongs are not designed to hold the plug in place
unit, you can refer to Quick Start Guide.
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
8. Unplug this product from the wall outlet before
cleaning. Do not use liquid or aerosol cleaners.
Use a damp cloth for cleaning.
9. Do not cut off the power adapters to replace them
with other plugs, as this causes a hazardous
situation.
10. Do not allow anything to rest on the power cords.
Do not install this product where the cords may be
walked on or crimped.
11. This product should be operated only from the
type of power source indicated on the marking
label. If you are not sure of the type of power
supply in your home, consult your dealer or local
power company.
12. Do not overload wall outlets or use an extension
cord.
13. Do not place this product on an unstable table,
shelf, stand or other unstable surfaces.
14. This product should not be placed in any area
where proper ventilation is not provided. Slots and
openings in the back or bottom of this product
are provided for ventilation. To protect them from
overheating, these openings must not be blocked
by placing the product on a soft surface such as
a bed, sofa or rug. This product should never be
placed near or over a radiator or heat register.
15. Never push objects of any kind into this product
through the slots because they may touch
dangerous voltage points or create a short circuit.
Never spill liquid of any kind on the product.
16. To reduce the risk of electric shock, do not
disassemble this product, but take it to an
authorized service facility. Opening or removing
parts of the product other than specified access
doors may expose you to dangerous voltages
or other risks. Incorrect reassembling can cause
electric shock when the product is subsequently
used.
17. You should test the sound reception every
time you turn on the units or move one of the
components.
18. Periodically examine all components for damage.
19. Be aware of possible loss of privacy while using
public airwaves. Conversations may be picked
up by other nursery monitors, cordless phones,
scanners, etc.
20. Children should be supervised to ensure that they
do not play with the product.
21. The product is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
SAVE THESE INSTRUCTIONS