Transcend TS64GSSD10-M Specification page 7

T S 6 4 G S S D 1
T S 6 4 G S S D 1
T S 6 4 G S S D 1
DC Characteristics
Signal
-IORD (-HDMARDY,HSTROBE)
-IOWR (STOP)
-CS0, -CS1
A00, A01, A02
-DMACK
D15 through D00
DMARQ
INTRQ
DSTROBE (-DDMARDY, DSTROBE)
-RESET
NOTE − Only those signals requiring termination are listed in this table. If a signal is not listed, series
termination is not required for operation in an Ultra DMA mode. Shows signals also requiring a pull-up or
pull-down resistor at the host. The actual termination values should be selected to compensate for transceiver
and trace impedance to match the characteristic cable impedance.
Electrical Characteristics
Parameter
Frequency Stability
Transcend Information Inc.
0 - M
0 - M
0 - M
Table: Series Termination for Ultra DMA
Host Termination
22 ohm
22 ohm
33 ohm
33 ohm
22 ohm
33 ohm
82 ohm
82 ohm
82 ohm
33 ohm
Value
30-80MHz
12
1.0" Solid State Disk
Device Termination
88 ohm
88 ohm
88 ohm
88 ohm
88 ohm
33 ohm
22 ohm
22 ohm
22 ohm
88 ohm
V1.6