Smart Command Set - Transcend TS64GSSD10-M Specification

T S 6 4 G S S D 1
T S 6 4 G S S D 1
T S 6 4 G S S D 1

SMART Command Set

SMART Command Set
D0h Read Data
D1h Read Attribute Threshold
D2h Enable/Disable Autosave
D3h Save Attribute Values
D4h Execute OFF-LINE Immediate
1. If reserved size is below the Threshold, the status can be read from Cylinder register by Return Status command
(DAh).
SMART Data Structure
BYTE
0-1
2-114
115-116
117-361
362
363
364-365
366
367
368-369
370
371
372
373
374
375-385
386-395
396-397
398-399
400
511
F=the content of the byte is fixed and does not change.
V=the content of the byte is variable and may change depending on the state of the device or
the commands executed by the device.
X=the content of the byte is vendor specific and may be fixed or variable.
R=the content of the byte is reserved and shall be zero.
* 4 Byte value : [MSB] [2] [1] [LSB]
Transcend Information Inc.
0 - M
0 - M
0 - M
SMART Feature Register Values
F / V
X Revision code
X Vendor specific
V Power cycle count (116=MSB, 115=LSB)
X Vendor specific
V Off line data collection status
X Self-test execution status byte
V Total time in seconds to complete off-line data collection activity
X Vendor specific
F Off-line data collection capability
F SMART capability
Error logging capability
F 7-1 Reserved
0 1=Device error logging supported
X Vendor specific
F Short self-test routine recommended polling time (in minutes)
F Extended self-test routine recommended polling time (in minutes)
F Conveyance self-test routine recommended polling time (in minutes)
R Reserved
F Firmware Version/Date Code
F Number of initial invalid block(396=MSB, 397=LSB)
V Number of run time bad block(398=MSB, 399=LSB)
V Number of spare block
V Data structure checksum
D5h Read Log
D6h Write Log
D8h Enable SMART Operations
D9h Disable SMART Operations
DAh Return Status
Decription
32
1.0" Solid State Disk
V1.6