Parameter Setup - LeCroy WaveMaster 8 Zi Getting Started Manual

Touch any of the measurements on the table display (under the grid display
area) to show its corresponding Measure dialog.

Parameter Setup

1. Touch the parameter tab (Px) of an unused location or one that you
want to change.
2. Under Type, select a measurement type:
Measure On Waveforms
Applies measurements directly on the waveform as indicated on the
Source1 control.
Math On Parameters
Performs math (addition, subtraction, multiplication, division) on
parameters indicated on the Source1 and Source2 controls.
Advanced Web Edit
Selecting this type uses Teledyne LeCroy's Processing Web for
measurement setup. This feature, available with the XWEB option,
allows you to chain practically unlimited math functions together for
operation on your waveform measurements.
3. Touch inside the Source1 field and select a channel, math trace,
memory trace, or other waveform to be measured.
4. If you selected Measure On Waveforms, touch inside the Measure
field and select a parameter from the pop-up menu.
922133-00 Rev A
Getting Started Manual
93