Message Bar; Turning On Channels And Traces - LeCroy WavePro 7Zi Getting Started Manual

WavePro 7 Zi and Zi-A Oscilloscopes
 Probe Cal - Cable Deskew - Opens the Probes Cal. dialog where
various Gain, Offset, Skew, Source, and Advanced controls are
available for probe signal calibration.
Another example is seen in the buttons appearing at the bottom of the
Measure Px dialogs. The button may be selected in order to display the
functions named on the buttons (sometimes labeled as Actions):
Using these buttons allow you to remain in the Measure dialog while
setting up a Math trace on a parameter measurement.

Message Bar

At the bottom of the oscilloscope display is a narrow message bar. The
current date and time are displayed at the far right. Status, error, or other
messages are also shown in this area.

Turning on Channels and Traces

Note: If you want to display each trace on its own grid automatically,
enable Autogrid by touching Display → Autogrid from the menu bar.
 On the front panel, press a channel select button to display the
trace label for that input channel and turn on the channel.
 Turn on a math function trace by touching Math → Math Setup...
from the menu bar. Touch the corresponding On checkbox to
activate the desired trace.
57
WP7Zi-GSM-E RevB