Table of Contents
Advertisement
Another example is seen in the buttons appearing at the bottom of the
Measure Px dialogs. The button may be selected in order to display the
functions named on the buttons (sometimes labeled as Actions):
Using these buttons allow you to remain in the Measure dialog while
setting up a Math trace on a parameter measurement.
Message Bar
At the bottom of the oscilloscope display is a narrow message bar. The
current date and time are displayed at the far right. Status, error, or
other messages are also shown in this area.
Turning on Channels and Traces
Note: If you want to display each trace on its own grid automatically,
enable Autogrid by touching Display → Autogrid from the menu bar.
On the front panel, press a channel select button to display the
trace label for that input channel and turn on the channel.
Turn on a math function trace by touching Math → Math Setup...
from the menu bar. Touch the corresponding On checkbox to
activate the desired trace.
You can also quickly create traces (and turn on the trace label) for
math functions and memory traces, without leaving the Vertical
Adjust dialog, by touching the icons at the bottom of the Vertical
Adjust dialog.
WR6Zi-GSM-E
Actions for Trace buttons on the Cx dialog.
Getting Started Manual
52
Advertisement
Table of Contents
