Adding Software Options; Remote Communication - LeCroy WavePro 7Zi Getting Started Manual

Adding Software Options

New software options can be added after purchasing a code and then
enabling the option on the oscilloscope. Call LeCroy Customer Support to
place an order and receive the code. Contact LeCroy for more Software
Option information and refer to the Contact LeCroy for Support (on page
177) topic in this manual for details.
 After adding new software options, the entire oscilloscope
application needs to be restarted. Do this by touching the desktop
shortcut.
 Restart the Windows® operating system on your instrument (if
necessary) by rebooting the oscilloscope. Do this by pressing the
power switch, and then turning the power back on after a ten-
second wait.

Remote Communication

From the Remote tab on the Utilities dialog, you can set up remote
communication. You can select a network communication protocol,
establish network connections, and configure the Remote Control
Assistant log from the Remote dialog. The choice of communication
protocols is limited to TCPIP and GPIB.
PLEASE NOTE THE FOLLOWING:

GPIB is an option and requires a GPIB card to be installed in a card
slot at the rear of the oscilloscope.
 The instrument uses Dynamic Host Configuration Protocol (DHCP) as
its addressing protocol. Therefore, it is not necessary to set up an IP
address if your network supports DHCP. If it does not, you can
assign a static address in the standard Windows 2000 network setup
menu.
The Remote Control Assistant monitors communication between your PC
and oscilloscope when you are operating the instrument remotely.
WP7Zi-GSM-E RevB
Getting Started Manual
152