Usb Configuration - LG Pro Centric 37LT777H Commercial Mode Setup Manual

(Continued from previous page)
4. Once all fields are completed as required, you have two
options (see also note below):
• To save the data entered and exit the wizard, use the arrow
keys to select Exit and then press OK. In the subsequent
pop-up confirmation window, select Save and Exit, and then
press OK once more. The Pro:Centric application and/or
E-Z Installation data will be downloaded to the TV at a later
time. This option is useful, in particular, if the Pro:Centric
server has not yet been configured.
• To initiate a real-time download of Pro:Centric application
and/or E-Z Installation data, use the arrow keys to select
Next, and then press OK.
The EZ-Manager Wizard will proceed with the remaining
Pro:Centric application and/or E-Z Installation data down-
load steps, as shown on the Processing the Pro:Centric
Configuration screen.
Note: With RF configuration, Pro:Centric server data must be
present on the RF channel selected as the TV's Data Channel
in order for you to select "Next" (you will see a "Data Channel
found" message below the signal strength indicator). With IP
configuration, Pro:Centric server data must be present via the
wired LAN cable connection in order for you to select "Next"
(you will see a "IP server found" message below the Port field).
When the Pro:Centric configuration is complete, an EZ-Manager
Configuration Complete screen is displayed, and after 10
seconds, the wizard exits, and the TV turns OFF.
Note: With the EZ-Manager Configuration Complete screen on
display, you also have the option to manually turn off or reboot
the TV. If desired, select Turn Off or Reboot, respectively, and
then press OK on the Installer Remote.

USB Configuration

Before you being, note the following:
• Each of these functions requires that you have the appropriate file(s) loaded on a USB memory
device. If you wish to perform a software upgrade from the USB Download Menu, the software
upgrade files must be stored in a folder named "LG_DTV" in the root directory of the USB
memory device. Cloning (.tll/.tlx) or FTG Configuration (.tlx) files should simply be stored in the
root directory of the USB device.
• If you intend to use the TV Zoning feature on this TV, make sure to assign the TV Zone # in the
EZ-Manager's Zone, Label, and Room Number screen BEFORE continuing with USB Configuration.
See "TV Configuration Options" on page 13 for further information.
206-4234
EZ-Manager Wizard (Cont.)
EZ-Manager Wizard
2
3 4
1
Pro:Centric Manual Configuration
Are you sure you want to exit the wizard?
!
<
Pro:Centric Mode If you select 'OK' now, your settings will be lost
and you will exit the setup wizard.
Channel Number
Signal Strength This window will close and you will be returned to
the previous page automatically in 2 seconds.
Signal Quality
Save and Exit OK
Back Exit
EZ-Manager Wizard
3 4
1 2
Processing the Pro:Centric Configuration...
Downloading the Pro:Centric application files takes a few minutes.
Please wait...
Retrieving files from data channel 75
Application files
Maintenance files
Warning - Do not remove AC power or the signal cables during these steps
EZ-Manager Wizard
4
2 3
1
EZ-Manager Configuration Complete
The TV will turn off in 3 second(s).
Installed Components
Pro:Centric Application
Maintenance Files
Reboot
>
GEM
1
0%
0%
Cancel
No signal
Next
1%
In progress...
Pending...
GEM application downloaded
LT777H_Config.tlx
Turn Off
17