Clone Programmer Cloning Procedures; Learning / Teaching A Master Tv Setup Using A Tll-1100A Clone Programmer - LG Pro Centric 37LT777H Commercial Mode Setup Manual

Learning / Teaching a Master TV Setup using a TLL-1100A Clone Programmer

Caution: If the TV is in LodgeNet PPV Mode or FTG Mode via EBL (check with the site
administrator if you are not certain), do not connect a clone programmer to the GAME
CONTROL/MPI port, as this will damage the clone programmer.
Cloning is accomplished using the
TV/clone programmer MPI ports for
communication (see figure).
TLL-1100A Cloning Notes
• Read the IMPORTANT CLONING
INFORMATION on page 36 before
beginning any cloning procedures.
• Ensure the TLL-1100A is either fully
charged or connected to AC power.
• Learning and Teaching is only
possible between identical model
TVs; however, the TLL-1100A can
store up to eight different Master
TV Setups.
Learn Setup from Master TV
1. Ensure the Master TV is set up completely and in Pass-through Mode.
2. Tune/set the TV to an analog channel or Aux input, and then, plug one end
of the MPI cable into the TV MPI port.
3. Turn ON the TLL-1100A.
4. Use the MODE button on the TLL-1100A to select Clone Mode.
5. Use the Left/Right arrows on the TLL-1100A to select the Memory CBank
(1 to 8) in which to store the Master TV Setup.
6. Plug the other end of the MPI cable into the MPI port on the bottom of the
TLL-1100A. The Clone Selection Menu will display on the TV screen.
7. Press 1 on the Installer Remote to select LEARN FROM TV from the
Clone Selection Menu. Then, press OK to transfer the Master TV Setup
into CBankX on the TLL-1100A.
Learning usually takes about 90 seconds. "LEARNING IN PROGRESS" will
be displayed on the screen while the TLL-1100A copies the Master Setup.
When the Learning process is complete, a "LEARNING COMPLETE"
message will be displayed.
8. When Learning is complete, disconnect the MPI cable from the Master TV.
206-4234

Clone Programmer Cloning Procedures

Antenna
or CATV
CLONE SELECTION MENU
Selected Bank: CBankX Saved
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
TLL-1100A Clone
TV Link
Programmer
Loader
MODE
MPI
Cable
RECEIVE
CLONE SELECTION MENU
Selected Bank: CBankX Saved
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
THE CLONE IS VERSION VX.X.X
-
To change menu items, press
channel keys or digits.
-
To execute item, press Enter.
TLL1100A
Ready
MENU
ENTER
SEND
TLL-1100A
41