Ip Stream Control - LG Pro Centric 37LT777H Commercial Mode Setup Manual

(Continued from previous page)
The TV will display a status screen as it confirms each of the
network elements, including the TV status, the gateway status,
the DNS status, and the Internet status (see example at right).
If the network is connected successfully, a "Wired/Wireless
network is connected" message will be displayed at the top of
the screen and the network configuration data will be displayed
in the lower half of the screen.
Note: If a problem is detected, the status screen will identify the
network element in which the connection failed. Check cabling
and/or configuration data, as necessary. If the status screen
is still on display, you can select Try again and press OK to
recheck the network status.
2. When the status screen shows that the network is connected,
select Complete (if not already selected) and press OK on the
Installer Remote to return to the IP Environment Menu.
Note: If you cancel the status check while it is in progress, the TV
will exit both the status window and the IP Environment Menu. If
you wish to return to the IP Environment Menu while the status
check is in progress, press

IP Stream Control

If necessary, due to an audio and/or video stream delay, IP Stream
Control options enable you to compensate for synchronization
irregularities by allowing audio PTS, video PTS, and PCR offset
modifications. This menu also enables you to specify the IGMP
version (2 or 3). Note that any modifications to these settings
should be performed by qualified personnel only.
1. With the IP Environment Menu on display, use the arrow keys
on the Installer Remote to select IP Stream Control. Then,
press OK.
2. In the IP Stream Control pop-up window, use the Up/Down
arrow keys on the Installer Remote to navigate to the
appropriate field: Audio PTS Offset, Video PTS Offset, PCR
Offset, or IGMP Version.
3. Use the Left/Right arrow keys to set the appropriate value for
the selected field.
Note: Offset values represent offset time in milliseconds (ms)
and can be adjusted from -500 ms to +500 ms in 10 ms
increments.
4. When you have completed all modifications as required, either
select Close and then press OK on the Installer Remote or
press to return to the IP Environment Menu.
206-4234
on the Installer Remote.
IP Environment Setup (Cont.)
Network Status
Wired network is connected.
TV Gateway
MAC Address : AA:BB:CC:DD:EE:23 Gateway
IP Address : 10.2.3.4
Subnet Mask : 255.255.255.0
Complete
IP Environment
IP Environment
• Network Connection
Audio PTS Offset
• Network Status Video PTS Offset
• IP Stream Control PCR Offset
• Pro:Centric IGMP Version
• Wake On LAN
• Media Share
• Pre-loaded Apps
DNS Internet
: 10.10.10.10
DNS Server : 10.5.6.7
Move OK
Move OK
<
>
0
<
>
0
< >
0
< >
2
Close
59