Flat Brace - Schwinn 12in Tiger Owner's Manual

Inner axle
Flat wheel brace
Brace
stabilizer
washer
Axle nut
training wheels
Stabilizer bracket
Washer
Axle nut
Wheel
brace
Training
wheel
48
©2010

Flat Brace

Remove the outer axle nut and washer from the rear wheel axle. Place the flat wheel
brace onto the axle. Next place the brace stabilizer washer onto the axle and align it
so that the notch fits into the rear frame drop out. Replace the washer and axle nut.
Tighten the axle nut securely, making sure that the wheel brace stays in the proper
vertical position. The elongated hole on the wheel brace allows the training wheel
height to be adjusted for proper fit. (Fig. 3.49)
Training Wheel Stabilizer Bracket
Training
Remove the outer axle nut and washer from the rear wheel axle. Insert the wheel brace
wheel
Inner axle nut
into the stabilizer bracket so that the forked end of the stabilizer bracket faces in. Slide
DO NOT REMOVE
assembly onto the rear axle so that the forked end hooks around the chain stay of the
bicycle. Replace the axle nut and washer, secure tightly. The elongated hole on the brace
3.49
allows for raising and lowering the training wheel to the proper height. (Fig. 3.50)
NOTICE: Not all bicycles will accept training wheels. If your bike did not come stock with
training wheels, please call Cycling Sports Group to help determine if after-market
can be attached.
3.50
It is very important to check the training wheel connection to the bicycle.
Failure to properly tighten may cause the training wheel to dislodge. Please
contact Cycling Sports Group Service with any questions.