Sony SRP-X700P Operating Instructions Manual page 25

Connectable projectors
Projectors meeting the following specifications can be connected.
• Equipped with RS-232C remote terminal
• The RS-232C remote terminal must support the following specifications.
Electrical characteristics : Conforming to RS-232C
Baud rate
Parity bit
Data length
Stop bit
Flow control
• The RS-232C remote terminal can be used to turn on the power, turn off the power, and select the input terminal.
Video signal systems and limitations
This system has the following limitations depending on the video signal system used and on the operation method.
The limitations are shown below.
• When component signal is used
The projector is equipped with the component signal input terminals.
The component signal and the RGB signal are used together.
The projector has a single input terminal which
accepts both the component signal and RGB signal
that are switched from the RS-232C remote terminal.
The projector has independent input terminals which
accept the component signal and RGB signal separately
that are switched from the RS-232C remote terminal.
The component signal and the RGB signal cannot be used together.
• When S VIDEO signal is used
The projector is equipped with the S VIDEO signal input terminal
The S VIDEO signal and the VIDEO signal are used together.
The projector can switch the S VIDEO signal input and
the VIDEO signal input from the RS-232C remote terminal.
The S VIDEO signal and the VIDEO signal cannot be used together.
: 9600, 19200 or 38400 bps
: None, odd or even
: 8 bits
: 1 bit
: None
Yes
Yes
No
No
Yes
Yes
No
No
The component signal
cannot be used.
No
There is no limitation.
Yes
There is no limitation.
Yes
A RGB signal distributor
is necessary.
No
The S VIDEO signal
cannot be used.
No
There is no limitation.
Yes
There is no limitation.
25