Supported Mibs; Snmp Traps; Remote Management: Snmp - ZyXEL Communications ZyWALL 2Plus User Manual

18.14.3 REMOTE MANAGEMENT: SNMP

To change your ZyWALL's SNMP settings, click ADVANCED > REMOTE MGMT >
SNMP. The screen appears as shown.
Figure 168 SNMP
The following table describes the labels in this screen.
Table 111 SNMP
LABEL
SNMP
Configuration
Get Community
Set Community
Trap
Community
Destination
SNMP
Service Port
Service Access
Chapter 18 Remote Management
DESCRIPTION
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using this
service.
ZyWALL 2 Plus User's Guide
315