Transceiver Installation; Transceiver Removal - ZyXEL Communications GS1510-16 User Manual

You can change transceivers while the Switch is operating. You can use different
transceivers to connect to Ethernet switches with different types of fiber-optic
connectors.
• Type: SFP connection interface
• Connection speed: 1 Gigabit per second (Gbps)
Note: To avoid possible eye injury, do not look into an operating fiber-optic module's
connectors.

3.1.2.1 Transceiver Installation

Use the following steps to install a mini GBIC transceiver (SFP module).
Insert the transceiver into the slot with the exposed section of PCB board facing
1
down.
Figure 10 Transceiver Installation Example
Press the transceiver firmly until it clicks into place.
2
The Switch automatically detects the installed transceiver. Check the LEDs to
3
verify that it is functioning properly.
Figure 11 Installed Transceiver

3.1.2.2 Transceiver Removal

Use the following steps to remove a mini GBIC transceiver (SFP module).
GS1510 Series User's Guide
Chapter 3 Hardware Overview
29