Setting The Time; Setting The Alarms - iHome iHM28 Operation Instruction Manual

1. Press and hold the Time Set/Sleep Button. The time will flash and a beep will sound. Press the – or + Button to set the
correct time (press and hold for rapid setting). Remember to set the correct AM or PM time. The AM and PM Indicators are
located to the left of the time digits.
2. Press either the or
(standard) display mode. The PM indicator will not appear when display is in 24 hour mode.
3. Press the Time Set/Sleep Button again. The year will flash. Press the – or + Button to set the correct year.
4. Press the Time Set/Sleep Button again. The date will flash. Press the – or + Button to set the correct date (press and
hold for rapid setting).
5. Press the Time Set/Sleep Button again (or no button press within 10 seconds) to exit the clock setting mode. 2 beeps will
confirm clock setting is complete.
This unit has a dual alarm system so you can set two separate alarms to different alarm times and sources.

Setting the Alarms

Note: Alarm 1 and Alarm 2 are set the same way; Alarm Button below means the button (
you are setting.
1. Press and hold the
and release the – or + Button
or PM time.
2. Press and release the Alarm Button again to confirm the set alarm time. The wake to icon will flash.
3. Press and release the
To wake to FM radio: The default wake to source is the current FM radio station. Press and release the
to set a different station (press and hold to scan to the next clear station). To wake to a preset station, press the presets
/Play Pause Button to cycle to the desired preset (see page 5 for details on setting presets).
To wake to Aux-in audio device: Press and release the
the display). At the set alarm time the unit will send a play command to the aux-in audio device currently connected via
the attached aux-in audio cable. NOTE: Some aux devices will not work with the aux-in alarm. Make sure to test your
device in aux-in mode before relying on it as a wake source. If the unit does not detect an aux audio device at the set
alarm time, the unit will default to buzzer alarm.
your audio device to last that long.
4. Press and release the Alarm Button again, then press and release
Dawn (amber fade leading up to alarm time), Flash (flashing red while alarm sounds), Glow (glowing color sequence while
alarm sounds) or None (no wakeup LED effect).
5. Press and release the Alarm Button again
confirm alarm setting is
lower part of the display will show the earliest set alarm time.

Setting the Time

Button at any time during clock setting to toggle the display between 24 hour (military) and 12 hour
Setting the Alarms
or Button until the alarm time flashes on the lower part of the display and a beep sounds. Press
to set the alarm time (press and hold for faster setting). Remember to set the correct AM
radio/aux Button to set the alarm wake-to source: FM radio or Aux-in.
(or no button within 10 seconds)
complete. The alarm will be armed once set and the corresponding alarm icon will light up. The
radio/aux Button
The alarm cycle lasts for one hour; make sure you have enough music on
the – or + Button to
4
or ) for whichever alarm
to cycle to aux-in mode (aux-in appears on
set the color LED wake cycle:
to exit the alarm setting mode.
– or + Button
2 beeps will