Setting The Time - iHome iBT280 Instruction Manual

Setting the Time

DST Switch
This unit has a Daylight Saving Time (DST) switch located on the back. By default, it is in Auto position
and will automatically adjust the time at the start and end of Daylight Saving Time in March and
November. If you are in a location that does not observe Daylight Saving Time or wish to set manually,
move the switch to +1 to add an hour or to -1 to subtract an hour.
1. Press and hold the Time Set Button. The time will flash and a beep will sound. Press the – or + Button
to set the correct time (press and hold for rapid setting). Take care to set the correct AM or PM time.
The AM and PM Indicators are located to the left of the time digits.
2. Press the Time Set Button. The year will flash. Press the – or + Button to set the correct year.
3. Press the Time Set Button again. The date will flash. Press the – or + Button to set the correct date
(press and hold for rapid setting).
TIP: Press either the
display between 24 hour (military) and 12 hour (standard) display mode. The AM/PM indicators will
not appear when display is in 24 hour mode.
4. Press the Time Set Button again (or no button press within 10 seconds) to exit clock setting mode.
2 beeps will confirm clock setting is complete.
or Button when display is flashing during clock setting to toggle the
Using the
6
iBT280