Related Manuals for iHome iH110
Summary of Contents for iHome iH110
- Page 1 Model iH110 Alarm Clock FM Radio ® for your iPod Questions? Visit www.ihomeaudio.com...
-
Page 2: Table Of Contents
Quick Start Controls and Indicators iH110 Display Install Clock Backup Battery Setting Up the iH110 Charging your iPod Listening to your iPod Listenng to FM Radio Listening to non-docking iPod or other portable audio device Alarm Operation Sleep Operation Snooze/Dimmer Operation... - Page 3 This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules.
-
Page 4: Quick Start
-1 +1 on off line in clock adj. DC 10V Attach AC adaptor cable to jack on back of the iH110 and plug the other end into a wall socket. iPod Touch Use this insert insert 14 For this iPod iPod Touch NOTE: If the insert for your iPod isn’t listed, please visit an Apple store or www.ihomeaudio.com... -
Page 5: Controls And Indicators
Controls and Indicators Alarm Set / Alarm On/Off Button Power/ Alarm Reset Button Snooze/Dimmer Button Clock Adj. Button DST Switch Line-in Jack Front Panel Mode/Wake-to Button iPod Dock Sleep Set Button FM Tune / Set / Adjust Up/Down Button Volume + Button Volume - Button Back Panel EXB Expanded Bass Switch... -
Page 6: Ih110 Display
Alarm Indicator iPod Indicator The iH110 uses a CR2032 button cell backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure... -
Page 7: Setting Up The Ih110
Failure to do so may damage your iPod. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). The iH110 will not overcharge your iPod. Note that other non-docking iPods will NOT charge. -
Page 8: Listening To Your Ipod
For enhanced bass, slide the EXB Expanded Bass Switch located on the back of the unit to the ON position. Note: If the playing song/music loudness is too low on the iPod, the iH110 may not detect that the iPod is in play mode. -
Page 9: Alarm Operation
Note: Please make sure your iPod has enough songs to play for one hour, otherwise please set the iPod repeat mode to ON. Note: If there is no iPod present or there is no music detected on the iPod at alarm time, the iH110 will automatically switch to buzzer alarm. -
Page 10: Sleep Operation
When the iH110 is off or while listening to your iPod, press the Sleep/Minute Set Button to enter sleep mode. The Sleep Icon will appear on the display to indicate it is in sleep mode. Sleep mode has a Gentle Sleep feature which gradually lowers the volume before it shuts off. -
Page 11: A Consumer Guide To Product Safety
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. -
Page 12: Trouble Shooting
Please refer to your iPod manual for details on iPod operation. generation iPod or other device iH110 cannot control those iPods or other devices. Remove your iPod from the connector and check for any obstruction on the connectors in the dock and on your iPod. -
Page 13: Solución De Problemas
Verifique que su iPod funcione correctamente antes de conectarlo a la unidad. Refiérase al manual de su iPod para más detalles. El iH110 no puede controlar estos otros aparatos Quite el iPod del encastre y retire la posible obstrucción del encastre o de su iPod. -
Page 14: Warranty Information
Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase.