Chassis Intrusion Connector - Asus VANGUARD B85 User Manual

6. Chassis intrusion jumper (4-1 pin CHASSIS)
This jumper is for a chassis-mounted intrusion detection sensor or switch. Connect one
end of the chassis intrusion sensor or switch cable to this jumper. The chassis intrusion
sensor or switch sends a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis intrusion event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
VANGUARD B85
VANGUARD B85 Chassis intrusion connector
7. Intel B85 Serial ATA 6.0Gb/s connector (7-pin SATA6G_1~4 [brown])
®
This connector connects to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0 Gb/s
signal cables.
VANGUARD B85 SATA 6.0Gb/s connectors
When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to [AHCI].
See section 2.6.3 SATA Configuration for details.
1-22
CHASSIS
PIN 1
SATA6G_1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA6G_2
GND
RSATA_TXP2
RSATA_TXN2
SATA6G_3
GND
RSATA_RXN2
RSATA_RXP2
GND
Chapter 1: Product introduction