Table of Contents
Advertisement
10.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled "Intruder" are shorted with a jumper cap. Remove
the jumper caps only when you intend to use the chassis intrusion detection
feature.
B85M-VIEW PAKER
B85M-VIEW PAKER Chassis intrusion connector
Before using this function, ensure that you enable it from Monitor > Chassis Intrude
Support in the BIOS Setup program.
11.
mSATA/mPCIe slot (MSATA_MPCIE)
This slot allows you to install a full length mSATA or mini-PCIe card, providing you with
expandability and connectivity solutions for an optimal system performance.
B85M-VIEW PAKER
B85M-VIEW PAKER mSATA/mPCIe combo slot
You can install either an mSATA card or an mPCIe card into this slot one at a time.
1-20
CHASSIS
PIN 1
MSATA_MPCIE
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the B85M-VIEW PAKER and is the answer not in the manual?