Table of Contents
Advertisement
11 KEY-LOCK
Push [SHIFT] + [8] to enable and disable the key-lock.
This symbol
shows on the LCD. Key-lock and Key-
Unlock icon is displayed for 2 seconds and then reverts
to show the TGID. The [PTT], [MON] and [SHIFT] key
are not locked. If [PTT], [MON] and [SHIFT] needs to
be locked, select DISABLE in the programming soft-
ware. If the station is to be remotely controlled it is rec-
ommended to leave [PTT] enabled, remote [PTT] will
not work when [PTT] is locked. To release key lock,
push [SHIFT] + [8] again.
Figure 24 shows Key locked.
Figure 25 shows Key unlocked.
RX
TX
C001
TAC 2
Key-Lock
Figure 24
RX
TX
C001
TAC 2
Key-Unlock
Figure 25
12 MANUAL CWID START AND
STOP
Push [SHIFT] + [A] to manually send the programmed
CWID.
CAUTION: The transmitter will energize immediately
when [A] is pushed.
To turn off CWID, push [SHIFT] + hold [B] for 2 sec-
onds. (This disables both programmed and manual
CWID.)
To return to normal operation, either reboot the radio
or push [SHIFT] + hold [B] for 2 seconds. (CWID must
be enabled in programming to use these functions.)
Figure 26 shows CWID Sending.
Figure 27 shows CWID function stop.
Figure 28 shows CWID function start.
CWID sending
Code: ICOM
C001
TAC 2
Figure 26
RX
TX
C001
TAC 2
CWID function stop
Figure 27
MD
N
MD
N
MD
N
MD
N
RX
TX
C001
TAC 2
CWID function start
Figure 28
13 DTMF ENCODE
Push [SHIFT] + [#] and then enter 0-9, [Q] or [#] to
transmit DTMF. The DTMF modulation level will be the
same as the CWID level.
Figure 29 displays DTMF Encode mode.
DTMF Encode
123456
Figure 29
14 ANALOG CHANNEL DATA
Push [SHIFT] + [7] to scroll through the data. [7] must
be depressed to scroll.
1) RX width (narrow/wide/4 kHz)
2) TX width (narrow/wide/4 kHz)
3) Base mode (Simplex/Semi-duplex/Duplex/Repeat-
er)
4) RX CTCSS/DCS, CTCSS and DCS are used in RX
5) TX CTCSS/DCS, CTCSS and DCS are used in TX
6) TX RX Modulation type either PM or FM (PM is the
default)
(Depending on the pre-setting, this information cannot
be displayed. Ask your dealer for details.)
Figure 30 displays indicates a narrow channel during
scroll.
RX
TX
C001
TAC 2
RX Narrow Channel
Figure 30
MD
N
MD
N
MD
N
6
Advertisement
Table of Contents
