Using The Cross Remote; Pairing With A Receiver - Sony DWTB01/E1424 Operating Instructions Manual

Using the Cross
Remote
This transmitter is equipped with a wireless
remote control function that can be used to
set the parameters (low-cut filter,
attenuation operation, power save mode,
etc.) of the transmitter through the receiver
or other devices. This function makes it
easier to operate and manage the
microphone system while in the field.
This wireless control is 2.4 GHz
IEEE802.15.4 compliant and has no effect
on the RF band of digital wireless audio.
This function is activated when pairing is
established between the transmitter and the
receiver using the RF REMOTE function.
Pairing must be done first before the
wireless remote control function can be
used.
Note
If "RESTRICTED BY GP/CH SETTING"
appears on the RF REMOTE screen, the
wireless remote control function cannot be
used. To use the wireless remote control
function, select a different transmission
channel.
For details on how to change the transmission
channel, see "Setting the Transmission Channel" on
page 10.

Pairing with a receiver

Pairing links the transmitter with the
receiver which the wireless remote control
function is to be used.
When the transmitter has been paired with a
receiver through the receiver operation,
turning on the transmitter while holding
down the – button establishes the pairing
immediately.
12

Using the Cross Remote

To carry out pairing through menu
operations on the transmitter, do the
following.
1
Set the receiver to be used for
controlling the transmitter to pairing
mode.
For details, refer to the operating instructions
supplied with the receiver.
2
Press the + or – button repeatedly until
the RF REMOTE indication is
displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or – button repeatedly to
select PAIRING.
5
Press the SET button to enter.
The transmitter sends a pairing request
to the receiver which is on pairing
mode.
Before established pairing, if you press
any operation key on the transmitter,
pairing mode will be cancelled.
When pairing has been established, the
wireless remote control condition level
(indicated by
REMOTE turns on, and the remote
control function becomes operative.
To use the Cross Remote with
a previous pairing
In the RF REMOTE indication, select ON.
Notes
• When you set RF REMOTE to ON, the
transmitter will communicate with the
receiver to which it was previously
paired. To use the wireless remote
control function with another receiver,
you must perform the pairing procedure
for that receiver.
) goes up, RF