Control Panel Key Operations For Controlling Fault Reporting; All Fault Reporting; Four Faults Only; Paper Out Only - Tally T6215 Maintenance Manual

Control Panel Key Operations For Controlling Fault Reporting

In addition to being able to use the above parameters to set up individual fault overrides, you
may also use three different key sequences to set up fault overrides. You may set up all fault
overrides, four specific overrides, or just Paper Out Fault override.
To use these, the printer must be in Tech Access Mode.

ALL Fault Reporting

To turn ALL fault reporting OFF, place the printer Offline and depress the FORM FEED Key and
ENTER Key simultaneously until the printer alarm sounds. To turn ALL fault reporting back ON,
hold down the same two keys when the printer is Offline until the printer alarm sounds.

Four Faults Only

To turn fault reporting OFF for Paper Motion, Paper Out, Ribbon Fault, and Platen Open
sensors, hold down the ENTER Key and TOF Key simultaneously until the printer alarm sounds.
To toggle them back ON, hold down the same two keys until the printer alarm sounds.

Paper Out Only

To turn OFF fault reporting for the Paper Out sensor, depress the Up Arrow Key and ENTER Key
simultaneously until the printer alarm sounds. To turn it back ON, depress the same keys until
the printer alarm sounds.
The displays that appear when you are enabling the options above can be somewhat confus-
ing. Just remember, when you turn on fault overrides you are losing fault protection.
Chapter 2. Menu Operations
2–15