Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION I NSTRUCTIONS- E LECTRICDRYER
Power
Supply
Cord
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal
(silver).
Ground wire (green or bare wire) must be connected to
green ground
connector.
Connect remaining 2 supply wires to remaining
2 terminals
(gold).
Securely tighten
all electrical
connections.
Failure to do so can result in death, fire, or
electrical shock.
2. Remove the hold-down screw and terminal block cover.
3. Install strain relief.
A. Neutral ground wire
B. External ground
conductor screw
C. Center, silver-colored
terminal block screw
D. Terminal block cover
and holddown screw
1. Disconnect power.
Electrical
Connection
Options
If your location
has:
And you will be
Go to Section
connecting to:
4-wire receptacle
(NEMA Type 14-30R)
(_
A UL listed, 120/240-
volt minimum,
30-amp, dryer power
supply cord*
4-wire connection:
Power supply cord
3-wire receptacle
(NEMA type 10-30R)
A UL listed, 120/240-
volt minimum,
30-amp, dryer power
supply cord*
3-wire connection:
Power supply cord
4-wire direct
_._t[[[_,[_,(,_
A fused disconnect or
4-wire connection:
circuit breaker box*
Direct Wire
(12.7 cm)
3-wire direct
_
A fused disconnect or
3-wire connection:
circuit breaker box*
Direct Wire
(8.9cm)
....
.....................................................
;;
r;
;
;;
; ...........................................................................
*If local codes do not permit the connection of a cabinet-ground
conductor to the neutral wire, go to "Optional 3-wire connection"
section.
13
Advertisement
Table of Contents
