Reversingthe Doorswing - Whirlpool CGW9100VQ0 Installation Manual

REVERSINGTHE DOORSWING
You can change your door swing from a right-side opening to
left-side opening, if desired.
Place a towel or soft cloth on top of the dryer or work space
to protect the surface.
1. Remove the 4 screws that hold the door hinge on the front
panel of the dryer.
1.
Use a small flat-blade screwdriver to remove 2 plug strips
from the inner door. Slide the head of the screwdriver under
the plugs, being certain not to scratch the inner door surface.
Lift up.
®
2. Remove the 4 screws that attach the door hinge and move
the hinge to the other side. Reinstall the 4 screws.
2.
3.
A. Dryer front panel
B. Door assembly
Lay the door assembly on a flat, protected surface with the
inside (inner door assembly) facing up.
Remove the 6 Phillips head screws to release the outer door
assembly from the inner door assembly, as indicated in the
illustration below. It is important that you remove only the 6
indicated screws.
A. Door hinge
3. Reinstall plug strips on opposite side of the inner door.
4. Check for fingerprints on the inside of the glass.
Clean glass if necessary.
5. Place the inner door assembly inside the outer door assembly.
To fit correctly, the inner door assembly edge fits completely
inside the outer door assembly edge.
6. Reassemble the inner and outer door assemblies with the
6 screws.
4. Lift the inner door assembly off the outer door assembly.
5. Rotate outer door 180 °.
180 °
21