Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION INSTRUCTIONS – ELECTRIC DRYER
Power Supply Cord
1. Disconnect power.
Electrical Connection Options
If your location has:
4-wire receptacle
(NEMA Type 14-30R)
3-wire receptacle
(NEMA type 10-30R)
4-wire direct
3-wire direct
*If local codes do not permit the connection of a cabinet-ground conductor to the neutral wire, go to "Optional 3-wire connection"
section.
And you will be
connecting to:
A UL listed, 120/240-
volt minimum,
30-amp, dryer power
supply cord*
A UL listed, 120/240-
volt minimum,
30-amp, dryer power
supply cord*
A fused disconnect or
circuit breaker box*
5"
(12.7 cm)
A fused disconnect or
circuit breaker box*
3
1
⁄
"
2
(8.9 cm)
2. Remove the hold-down screw and terminal block cover.
3. Install strain relief.
D
C
B
A
A. Neutral ground wire
B. External ground
conductor screw
C. Center, silver-colored
terminal block screw
D. Terminal block cover
and holddown screw
Go to Section
4-wire connection:
Power supply cord
3-wire connection:
Power supply cord
4-wire connection:
Direct Wire
3-wire connection:
Direct Wire
13
Advertisement
Table of Contents
