CLI Commands, Continued...
Save or Reset the Configuration Settings
Command Name
Description
Syntax
Parameters
Examples
NOTES
Show or Set IGMP Configuration
Command Name
Description
Syntax
Parameters
Examples
NOTES
(Revised 2011-07-21)
config
Save or reset configuration settings
config s[ave] | r[eset]
save
save current running configuration settings.
reset
reset configuration settings to factory defaults.
N-TRON/Admin> config save
Save Settings...
Settings have been saved.
N-TRON/Admin> config reset
Resetting to factory defaults...
Load factory default settings [y/n]?y
Keep IP, subnet mask, and gateway addresses [y/n]?y
Keep current user names and passwords [y/n]?y
...
igmp
Show or set IGMP configuration. If no parameters are specified, this command will show
the IGMP configuration (same as -show parameter).
igmp [-show] [-status state]
-show
Show configuration.
-status state
Set the IGMP status to e(nabled) or d(isabled).
N-TRON/Admin> igmp –show
IGMP Status
IGMP Version
Query Mode
CIP Querier Status
Active Querier IP
Router Mode
Manual Router Ports
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin> igmp –status disabled
IGMP Status
IGMP Version
Query Mode
CIP Querier Status
Active Querier IP
Router Mode
Manual Router Ports
IGMP Number of Groups : 1
IGMP Resource Usage % : 1
N-TRON/Admin>
: Enabled
: 2
: Auto
: 2, Active-Auto
: 192.168.1.250
: Auto
: (None)
: Disabled
: 2
: Auto
: 2, Active-Auto
: 192.168.1.250
: Auto
: (None)
Page 136 of 158