Bake Element; Broil Element; Oven Sensor - Maytag Gemini MER6770AAW Service Manual

Bake Element

Element Wattage: 208/240 volts @ 2250/3000
watts. Approximately 19
The bake function controls the Bake and
Broil heating elements. During a Bake cycle,
the Broil element will be on 6 seconds of a
60-second duty cycle, and then the Bake
element will be on the remaining 54
seconds. The Bake and Broil elements will
be staged with the exception of the rapid
preheat. In the rapid preheat, available when
the upper oven is used alone, the bake and
broil elements will be on at 100% until
temperature is reached. Once temperature
is reached, the elements will cycle as
outlined above.
Note: The Bake element will be the first
element to turn on at the beginning of any
conventional bake cycle.
To Access Bake Element:
1. Disconnect the appliance from power
source before servicing.
2. Remove lift off door for more
accessibility.
3. Remove four (4) screws securing bake
element to back of oven cavity.
4. Gently pull element through cavity wall
until terminals can be accessed.
5. Disconnect wiring.
6. Remove/replace element as necessary.
7. Reverse procedure to reinstall.

Broil Element

The broil function controls only the broil
element. The bake element is inactive
during a broil cycle. During a broil cycle, the
control will monitor the oven temperature
and cycle the broil element on and off to
obtain the selected temperature.
16010107
Ω
©2000 Maytag Appliances Sales Company
To Access Broil Element:
1. Disconnect the appliance from power
source before servicing.
2. Remove lift off door for more
accessibility.
3. Remove broil support brackets (2) and
remove screws securing broil element to
back oven.
4. Gently pull element through cavity wall
until terminals can be accessed.
5. Disconnect wiring.
6. Remove/Replace element as necessary.
7. Reverse procedure to reinstall.

Oven Sensor

The oven sensor is located inside the oven
cavity, attached to the rear wall of the cavity.
As the oven temperature increases, the
resistance of the oven sensor increases. The
resistance is measured by the electronic
control to determine the oven temperature.
To Access Oven Sensor:
1. Disconnect the appliance from power
source before servicing.
2. Open oven door and remove two (2)
screws securing sensor to oven cavity.
Gently pull through cavity wall.
3. Disconnect the oven sensor at the
connector blocks and remove/replace as
necessary.
4. Reattach the connector blocks and
reassemble.
Section 3. Component Description
3-3