Oven Sensor; Bake Element; Broil Element; Convection Fan Assembly - Maytag AER5515QA Series Service Manual

Electric freestanding range
Table of Contents

Advertisement

Disassembly Procedures
!

Oven Sensor

1. Disconnect power before servicing.
2. Open oven door and remove screws securing sensor
to oven cavity.
NOTE: Gently pull wiring through cavity wall.
3. Disconnect oven sensor at the connector terminal
and remove.
4. Reverse procedure to reinstall sensor.
NOTE: Verify connection is pushed through the
insulation.
Oven Senor

Bake Element

1. Turn off power to unit.
2. Remove screws securing oven bottom cover.
3. Raise the back of the bake element cover and slide
cover back to release the front edge of cover and lift
out of oven cavity.
4. Remove screws securing bake element to rear of
oven wall.
3. Pull element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedure to reinstall bake element.

Broil Element

1. Turn off power to unit.
2. Remove screws securing broil element to top and
rear of oven cavity.
3. Pull broil element forward to allow disconnection of
terminals on each element leg.
4. Reverse procedure to reinstall broil element.

Convection Fan Assembly

1. Turn off power to unit.
2. Open oven door or remove oven door, see "Door
Removal".
3. Remove screws securing convection fan cover to
convection fan assembly.
4. Remove screws securing convection fan assembly to
rear of oven cavity.
5. Slide convection fan assembly down and tilt forward
on the top portion to allow assembly to pass through
rear oven cavity.
©2004 Maytag Services
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
6. Disconnect and label wires from convection fan
motor.
7. Reverse procedure to reinstall convection fan
assembly.

Ribbon and Halogen Elements

1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5.
2. Remove screws securing element support bracket to
maintop.
3. Label and disconnect wire terminals from element
being replaced.
4. Release metal clips securing element to element
support bracket.
5. Replace and reverse procedure to reinstall element.
Drip Baffle Removal ( if so equipped )
1. Remove surface elements and burner bowls.
2. Raise and secure maintop assembly.
3. Remove screws securing drip baffle to range front
frame and side panels.
4. Reverse procedure to reinstall drip baffle.

Automatic Oven Door Latch Assembly

1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5 and "Drip Baffle"
procedures (if so equipped).
2. Remove screws securing latch assembly to the front
of the oven cavity outer shell.
3. Disconnect and label wire terminals from latch
assembly.
4. Remove screws securing latch assembly to the back
of the unit chassis.
5. Reverse procedure to reinstall door latch assembly.

Door Plunger Light Switch

1. Remove maintop assembly, see "Maintop Assembly"
procedure, steps 1 through 5, and "Drip Baffle"
procedures (if so equipped).
2. Label and disconnect wire terminals from switch.
3. Slide metal sleve forward and flex wire to release
from door plunger light switch.
4. Squeeze metal tab's and push switch inward to
remove.
5. Reverse procedure to reinstall door plunger light
switch.
NOTE: Be sure to install door plunger light switch heat
shield on new switch when replacing switch.
16025644
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents