Getting Started
Use reasonable care when opening and closing the display panel.
Opening it vigorously or slamming it shut could damage the computer.
Turning on the power
This section describes how to turn on the power.
After you turn on the power for the first time, do not turn it off until you have
set up the operating system. Refer to the section
1. If the external floppy disk drive is connected, make sure it is empty. If a
floppy disk is in the drive, press the eject button and remove the floppy
disk.
2. Open the display.
3. Press and hold the computer's power button for two or three seconds.
3-6
Figure 3-4 Opening the display
Figure 3-5 Turning on the power
Display latch
Windows XP
setup.
Power button
User's Manual