Toshiba Tecra M2 User Manual page 134

HW Setup
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Built-in HDD −>
2nd HDD −> PC
Card(Default)
2nd HDD −> Built-
in HDD −> PC Card
Built-in HDD −> PC
Card −> 2nd HDD
2nd HDD −> PC Card
−> Built-in HDD
PC Card −> Built-
in HDD −> 2nd HDD
PC Card −> 2nd HDD
−> Built-in HDD
If a boot command is not found on the first detected HDD, the system will
not boot from the other HDD. It will search the next device in the boot
priority for a boot command.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
PC card HDD boot is supported only by the PC card slot on the
computer. Support is guaranteed only for TOSHIBA PC card HDDs.
When you assign a PC card HDD top priority, "PC" is not displayed.
However, the PC card HDD takes the position of HDD in the Boot
Priority Options list above.
Some modules may not be displayed.
7-6
The computer will look for the Built-in HDD first,
next the 2nd HDD and then the PC Card
(Default).
The computer will look for the 2nd HDD first, next
the Built-in HDD and then the PC Card.
The computer will look for the Built-in HDD first,
next PC Card and then the 2nd HDD.
The computer will look for the 2nd HDD first, next
the PC Card and then the Built-in HDD.
The computer will look for the PC Card first, next
the Built-in HDD and then the 2nd HDD.
The computer will look for the PC Card first, next
the 2nd HDD and then the Built-in HDD.
[PXE] Sets PXE as the protocol. (Default)
[RPL] Sets RPL as the protocol.
User's Manual